Mechanotechnics N6: Belt tension ratio and power (angle of lap)

Belt drives · 8 marks · free worked example

Share with your class:WhatsAppFacebookX

Question

A flat belt runs over a pulley with an angle of lap of 165°. The coefficient of friction between the belt and the pulley is 0.3. The tension in the tight side is 2.5 kN and the belt speed is 15 m/s. Ignore centrifugal tension. Calculate the tension in the slack side and the power transmitted.

Given

  • θ=165∘\theta = 165^\circ
  • μ=0.3\mu = 0.3
T1=2.5 kN=2 500 N\begin{aligned} T_1 &= 2.5\ \text{kN} \\ &= 2\,500\ \text{N} \end{aligned}
  • v=15 m/sv = 15\ \text{m/s}

Solution, step by step

Angle of lap in radians:

θ=165×π180=2.8798 rad\begin{aligned} \theta &= 165 \times \frac{\pi}{180} \\ &= 2.8798\ \text{rad} \end{aligned}

Tension ratio:

T1T2=eμθ=e0.3×2.8798=2.3725\begin{aligned} \frac{T_1}{T_2} &= e^{\mu \theta} \\ &= e^{0.3 \times 2.8798} \\ &= 2.3725 \end{aligned}

Slack-side tension:

T2=T12.3725=2 5002.3725=1 053.74 N\begin{aligned} T_2 &= \frac{T_1}{2.3725} \\ &= \frac{2\,500}{2.3725} \\ &= 1\,053.74\ \text{N} \end{aligned}

Power transmitted:

P=(T1−T2) v=(2 500−1 053.74)×15=21 693.90 W=21.69 kW\begin{aligned} P &= (T_1 - T_2)\,v \\ &= (2\,500 - 1\,053.74) \times 15 \\ &= 21\,693.90\ \text{W} \\ &= 21.69\ \text{kW} \end{aligned}

Answer: T2T_2 is 1 053.74 N and the belt transmits 21.69 kW.

Mistakes to avoid

  • The angle of lap must be in radians in e^(μθ). Using degrees is the most common mistake.
  • T₁ is always the tight (bigger) tension.
  • If the question gives the mass per metre of the belt, the centrifugal tension mv² must be subtracted first.

Get every question of your own paper explained like this

Upload your Mechanotechnics N6 question paper and its memo. Get Good works out every question, checks the memo against the paper and lets you ask the AI tutor about any step.

More free worked examples

All worked examples →